PCE279.1001 Cylinder Head Stud Kit For Small Block Chevy SBC 265 267 283 302 350

Cylinder Head Stud Kit for Small Block Chevy SBC 265 267 283 302 350

PCE279.1001 cylinder head stud kit cross-references OE-style head fasteners for small block Chevy engines displacing 265, 267, 283, 302, and 350 cubic inches.

Overview

This cylinder head stud kit for Small Block Chevy is built to replace factory head bolts with reusable studs and nuts for improved clamping consistency. The kit suits engine builders, racers, and rebuilders working on 265, 267, 283, 302, or 350 cubic inch SBC platforms. Each cylinder head stud kit is intended for performance assembly and teardown cycles.

Built For Performance

• Stud-and-nut design delivers more even clamping load across the head gasket
• Reusable hardware stands up to repeated assembly and disassembly without stretch loss
• Made for small block Chevy 265, 267, 283, 302, and 350 cylinder heads
• Reduces thread wear in the block compared with repeated bolt torquing
• Suited to high-compression and boosted builds requiring consistent fastener tension

Fits These Machines

• for Chevrolet Small Block 265
• for Chevrolet Small Block 267
• for Chevrolet Small Block 283
• for Chevrolet Small Block 302
• for Chevrolet Small Block 350

On-The-Job Use

• Engine rebuilds and short block assembly
• Cylinder head gasket replacement
• Performance and race engine builds
• Boosted and high-compression setups

Specs At A Glance

Good To Know

Q: Do I need to retorque after installation? A: Many builders recheck torque after the first heat cycle. Follow the tightening sequence and torque specs published for your specific small block Chevy build.

Q: Can these be used more than once? A: Studs and nuts are generally reusable if threads and shanks are undamaged and torque values stay within range. Inspect each piece before reuse.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.