Power Steering Rack Pinion Assembly For LEXUS RX330 RX350 Toyota Highlander

Power Steering Rack Pinion Assembly for Lexus and Toyota

This power steering rack and pinion assembly replaces the worn steering gear on the listed Lexus and Toyota models, restoring precise steering response and eliminating play at the wheel.

Overview

This power steering rack and pinion assembly is a direct replacement steering gear for the listed Lexus and Toyota vehicles. It converts steering wheel input into linear motion at the tie rods so the driver keeps accurate control at any speed. Ideal for owners facing leaky seals, loose steering, or a failed original rack on a high-mileage SUV.

Built For Performance

• Complete rack and pinion assembly ready for direct installation
• Machined housing and internal gears built to original dimensions
• Sealed hydraulic ports to prevent fluid leaks under pressure
• Pre-loaded pinion bearing for consistent steering feel
• Corrosion-resistant coating on the housing for long service life
• Tested for smooth travel across the full steering range

Fits These Machines

• for Lexus RX330
• for Lexus RX350
• for Toyota Highlander

On-The-Job Use

• Daily driving and commuting in the listed SUVs
• Replacing a leaking or binding original steering rack
• Restoring factory steering effort after rack failure
• General front-end and steering system service

Specs At A Glance

Good To Know

Q: Is this an original Lexus or Toyota part? A: No, this is an aftermarket replacement rack and pinion assembly made to fit the listed Lexus and Toyota models. It is not produced by Lexus or Toyota.

Q: Does replacing the rack require an alignment afterward? A: Yes, a front-end alignment is recommended after installing any steering rack and pinion assembly. This helps ensure even tire wear and correct steering centering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.