Power Trim Sensor 896688001 for Mercury Mariner 135/150/175/225/250HP Outboard

Power Trim Sensor for Mercury Mariner

This power trim sensor for Mercury Mariner outboards monitors the trim and tilt position of the drive unit and sends the signal to the gauge, replacing OEM part number 896688001.

Overview

The power trim sensor for Mercury Mariner outboards provides accurate trim position feedback for the instrumentation. This power trim sensor replaces OEM part number 896688001 and is tailored for Mercury Mariner outboards in the 135 to 250 horsepower range. With this power trim sensor, the operator can confirm the drive angle while trimming the boat.

Built For Performance

• Replacement sensor designed to match OEM number 896688001
• Provides electrical trim position signal to the gauge
• Built for use with Mercury Mariner outboard trim systems
• Designed for outboard trim bracket installation
• Constructed with corrosion-resistant materials for marine environments

Fits These Machines

• for Mercury Mariner 135hp outboard
• for Mercury Mariner 150hp outboard
• for Mercury Mariner 175hp outboard
• for Mercury Mariner 225hp outboard
• for Mercury Mariner 250hp outboard

On-The-Job Use

• Used while adjusting drive trim during high-speed runs
• Used for verifying drive position when launching or beaching
• Used in stop-and-go boating to correct bow rise
• Applied in routine checks of trim and tilt system response

Specs At A Glance

Good To Know

Q: Does this power trim sensor require a separate harness? A: This listing is for the power trim sensor only. Confirm the existing connector and wiring are correct for the application.

Q: What should I check before installation? A: Verify the sensor part number and the serial number range of the outboard to confirm fitment before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.