Prop Shaft Assembly Rear Shaft For 08-12 Ford Escape Mercury Mariner 08-11 4WD

Rear Prop Shaft Assembly for Ford Escape and Mercury Mariner 4WD

This rear prop shaft assembly replaces the factory driveshaft on 2008-2012 Ford Escape and 2008-2011 Mercury Mariner 4WD models, delivering torque from the transfer case to the rear axle.

Overview

This rear prop shaft assembly is a direct-fit replacement for worn or damaged driveshafts on Ford Escape and Mercury Mariner 4WD models. The prop shaft assembly restores reliable power transfer to the rear wheels and eliminates vibration, clunking, and driveline noise. It suits DIY owners and shops completing a rear driveline repair.

Built For Performance

• Balanced steel tubing to minimize vibration across the RPM range
• Pre-installed U-joints for straightforward bolt-on installation
• Machined yokes sized for the Escape and Mariner transfer case and rear differential
• Protective coating against rust and road debris
• Factory-matched length and spline count for 4WD drivetrains

Fits These Machines

• for Ford Escape 4WD 2008-2012
• for Mercury Mariner 4WD 2008-2011

On-The-Job Use

• Replacing a bent or failing rear driveshaft after collision or off-road damage
• Restoring 4WD engagement on high-mileage Escape and Mariner SUVs
• Driveline service alongside transfer case or differential repairs
• Curing vibration and clunking traced to worn U-joints or shaft imbalance

Specs At A Glance

Good To Know

Q: Does this prop shaft fit two-wheel-drive models? A: No, this assembly is built for 4WD Escape and Mariner models only. Check your drivetrain configuration before ordering.

Q: Are the U-joints already installed? A: Yes, the U-joints come pre-installed so the shaft mounts directly to the transfer case and rear axle. Inspect the mounting bolts and replace them if worn.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.