Rear Axle Bearing Removal Puller Tool 09521-25011 for Toyota Trucks 1984-2018

Rear Axle Bearing Removal Puller Tool for Toyota Trucks

This rear axle bearing removal puller tool, reference 09521-25011, is designed to press out stubborn rear axle bearings and seals on Toyota trucks so you can complete axle service without damaging the housing.

Overview

The rear axle bearing removal puller tool for Toyota trucks gives you the leverage and control needed to extract pressed-in axle bearings and seals cleanly. Built to match the 09521-25011 reference, this puller works with slide hammer and driver setups to pull bearings straight from the axle tube. It is a practical addition for mechanics and DIY owners servicing older Toyota truck rear ends.

Built For Performance

• Slide hammer and adapter design delivers controlled pulling force on seized bearings
• Heavy duty steel construction resists flexing under repeated shop use
• Drop forged components hold up against high torque loads
• Collets and adapters sized to grip the bearing race securely
• Reference 09521-25011 for straightforward cross matching
• Works with common puller slides and dent puller attachments

Fits These Machines

• for Toyota Trucks 1984-2018

On-The-Job Use

• Rear axle bearing and seal replacement on shop lifts
• Drivetrain repair for older Toyota truck rear ends
• Trailside or home garage axle service
• Fleet maintenance and rebuild jobs

Specs At A Glance

Good To Know

Q: Does this tool remove both the bearing and the seal? A: The puller is intended to press the rear axle bearing out of the housing, and the seal is typically pulled with the same setup or replaced afterward.

Q: Will this work on all Toyota truck rear axles? A: It is referenced for 1984-2018 Toyota trucks, but axle design can vary by model and year, so verify your bearing style before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.