Rear Axle Differential Carrier Assembly AWD For Mazda CX-5 CX-9 2.5L KA0327020#
Rear Axle Differential Carrier Assembly AWD For Mazda CX-5 CX-9 2.5L KA0327020#
Couldn't load pickup availability
Rear Axle Differential Carrier Assembly for Mazda CX-5 CX-9
This rear axle differential carrier assembly for Mazda CX-5 and CX-9 with 2.5L AWD drivetrains, referenced under part number KA0327020, transfers torque to the rear wheels as a complete replacement unit.
Overview
This rear axle differential carrier assembly for Mazda CX-5 and CX-9 is a complete rear differential unit built for all-wheel-drive 2.5L vehicles. It transfers engine torque to the rear wheels and houses the ring and pinion, carrier, and bearings in one assembled component. It suits owners and shops replacing a noisy, leaking, or failed rear differential with a ready-to-install carrier.
Built For Performance
- Complete rear carrier assembly with internal differential components installed
- Built for 2.5L all-wheel-drive drivetrain configurations
- Cross-references part number KA0327020
- Assembled unit reduces the need to rebuild an existing differential
- Housing designed for factory rear axle mounting points
Fits These Machines
- for Mazda CX-5 with 2.5L AWD
- for Mazda CX-9 with 2.5L AWD
On-The-Job Use
- Replacing a worn or noisy rear differential in an AWD SUV
- Servicing drivetrain repairs after differential fluid loss
- Restoring rear-wheel drive engagement on an all-wheel-drive vehicle
- Shop installs where a complete carrier saves rebuild time
Specs At A Glance
| Part Number(s) | KA0327020 |
| Position | Rear |
| Component | Differential Carrier Assembly |
| Drivetrain | AWD |
| Engine | 2.5L |
Good To Know
Q: Is this a direct bolt-in replacement? A: It is designed to mount at the factory rear differential location, but gear ratio and drivetrain configuration should be matched to your vehicle. Confirm your axle and trim details before ordering.
Q: Does it come fully assembled? A: It is supplied as a complete carrier assembly with the internal differential components in place. Fluid and installation hardware should be sourced separately as needed.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
