Rear Back Wide Grab Bar Bumper Carrier For 1988-2006 Yamaha Blaster 200 YFS200

Rear Wide Grab Bar Bumper Carrier for Yamaha Blaster 200 YFS200

This rear wide grab bar bumper carrier bolts to the back of the Yamaha Blaster 200 YFS200 to give riders a sturdy grab point and rear protection in one unit.

Overview

This rear grab bar bumper carrier is made for the Yamaha Blaster 200 YFS200 and mounts directly to the rear frame to provide a solid lift handle plus added rear-end protection. Riders use the grab bar to help move the quad or recover it from a stuck position, while the carrier section shields the rear plastics from light impacts. It suits Yamaha Blaster 200 owners replacing a bent, cracked, or missing rear grab bar.

Built For Performance

• Wide grab loop provides a full-hand grip for lifting and moving the quad
• Rear carrier shape adds a protective barrier behind the rear plastics
• Steel construction resists bending under repeated pulling loads
• Bolt-on mounting matches the factory rear frame points
• Powder-coated finish helps resist rust and trail debris

Fits These Machines

• for Yamaha Blaster 200 YFS200 (1988-2006)

On-The-Job Use

• Lifting the rear of the quad onto a stand or trailer
• Pulling the machine free when it gets stuck in mud or ruts
• Guarding rear plastics during trail riding
• Adding a rear tie-down point for transport

Specs At A Glance

Good To Know

Q: Does this grab bar fit every Yamaha Blaster 200 YFS200 year? A: It is listed for the 1988-2006 Yamaha Blaster 200 YFS200 range. Check your model year and rear frame mounting points before ordering.

Q: Can I install this without drilling? A: It is designed to bolt to the factory rear frame points on the Blaster 200. Confirm the mounting holes on your machine line up before purchase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.