Rear CV Axle Drive Shaft 1334175 1333756 for Polaris Ranger Crew XP 1000 900 EPS

Rear CV Axle Drive Shaft for Polaris Ranger Crew XP 1000 900 EPS

This rear CV axle drive shaft, referenced under part numbers 1334175 and 1333756, is a constant velocity axle assembly that transfers power from the rear differential to the wheel hub on Polaris Ranger Crew XP 1000 and 900 EPS machines.

Overview

This rear CV axle drive shaft is a replacement assembly for the rear driveline on Polaris Ranger Crew XP 1000 and 900 EPS models. It carries torque from the differential out to the wheel while allowing suspension travel through its constant velocity joints. Built for riders who need to restore or refresh a worn rear axle, it is a direct-fit style component referenced under part numbers 1334175 and 1333756.

Built For Performance

• Constant velocity joint design allows smooth power delivery through suspension travel
• Heavy-duty shaft construction sized for the torque of 1000 and 900 class engines
• Pre-assembled with boots and joints for a bolt-on replacement
• Boots help seal out dirt, water, and debris from the joint internals
• Rear position fitment matched to Ranger Crew XP axle geometry

Fits These Machines

• for Polaris Ranger Crew XP 1000
• for Polaris Ranger Crew XP 900
• for Polaris Ranger Crew XP 1000 EPS
• for Polaris Ranger Crew XP 900 EPS

On-The-Job Use

• Replacing a clicking, torn-boot, or broken rear axle on a Ranger Crew
• Ranch and property work where the machine carries loads over rough ground
• Trail riding and hunting access where rear driveline reliability matters
• Routine driveline maintenance on high-hour utility machines

Specs At A Glance

Good To Know

Q: Is this an original Polaris part? A: No, this is an aftermarket rear CV axle drive shaft that cross-references part numbers 1334175 and 1333756. It is not manufactured by Polaris.

Q: Should I replace both rear axles at once? A: If the opposite axle has similar hours or shows boot damage, replacing both can save a second teardown. Inspect the other side before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.