Rear Drive Shaft Assembly for BMW E90 325i 2006 328i 2007-2013 Automatic Trans

Rear Drive Shaft Assembly for BMW E90

This rear drive shaft assembly is a direct replacement prop shaft that transfers torque from the transmission to the rear differential on BMW E90 models with automatic transmissions.

Overview

This rear drive shaft assembly is built as a complete replacement prop shaft for BMW E90 325i and 328i models equipped with an automatic transmission. The driveshaft delivers engine power from the gearbox to the rear differential, keeping the drivetrain operating smoothly. It suits owners of 2006 325i and 2007-2013 328i sedans who need a fresh shaft for a worn or damaged original.

Built For Performance

• Balanced shaft tube to reduce vibration at highway speeds
• Precision-machined yokes for a secure differential and transmission fit
• Serviceable universal joints for long-term driveline reliability
• Heat-treated construction to handle continuous torque loads
• Direct-fit dimensions for BMW E90 automatic transmission applications

Fits These Machines

• for BMW 325i 2006 E90 automatic transmission
• for BMW 328i 2007-2013 E90 automatic transmission

On-The-Job Use

• Replacing a bent or vibrating factory driveshaft
• Restoring driveline balance after a u-joint failure
• Routine drivetrain maintenance on automatic E90 sedans
• Correcting power transfer issues between transmission and rear differential

Specs At A Glance

Good To Know

Q: Does this driveshaft fit both manual and automatic BMW E90 models? A: This assembly is intended for automatic transmission applications, so confirm your transmission type before ordering. Q: Are new mounting hardware and bolts included? A: This listing covers the driveshaft assembly itself, so check your original fasteners and replace them if worn.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.