Rear Driveshaft Prop Shaft Assy For Chevy Silverado 2500 HD GMC Sierra 2500 RWD

Rear Driveshaft Prop Shaft Assembly for Chevy Silverado 2500 HD and GMC Sierra 2500 RWD

This rear driveshaft prop shaft assembly transfers torque from the transmission to the rear axle on Chevy Silverado 2500 HD and GMC Sierra 2500 RWD trucks.

Overview

This rear driveshaft prop shaft assembly is a direct-fit replacement for the factory two-piece or one-piece shaft on Chevrolet Silverado 2500 HD and GMC Sierra 2500 two-wheel-drive trucks. It carries engine torque from the transmission output to the rear differential, keeping the driveline smooth under load. It suits truck owners and shops replacing a bent, worn, or vibration-prone shaft.

Built For Performance

• Balanced steel tube construction to reduce driveline vibration
• Welded yoke ends and tube for durable torque transfer
• Direct-fit length and spline count for the listed RWD applications
• Includes shaft assembly ready for installation with new U-joints as equipped
• Built to handle towing and hauling loads on 2500 HD and 2500 trucks

Fits These Machines

• for Chevy Silverado 2500 HD RWD
• for GMC Sierra 2500 RWD

On-The-Job Use

• Replacing a bent or dented driveshaft after impact
• Curing driveline vibration and clunk under acceleration
• Restoring towing and hauling capability to work trucks
• Scheduled driveline service on high-mileage trucks

Specs At A Glance

Good To Know

Q: Will this driveshaft fit my truck directly? A: It is built for Chevy Silverado 2500 HD and GMC Sierra 2500 RWD models, but cab, bed, and engine combinations can change shaft length, so confirm your specs first. Q: Does this work on 4WD trucks? A: This assembly is sized for rear-wheel-drive trucks; four-wheel-drive models use a different front and rear shaft setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.