Rear Fender Fascia w/LED Tail Light For 2009-13 Harley Street Road Electra Glide

Rear Fender Fascia with LED Tail Light for Harley Street Glide, Road Glide, Electra Glide

This rear fender fascia with LED tail light fills the gap below the rear fender on 2009-2013 Harley Touring models and adds a low-profile LED tail light for running and brake functions.

Overview

This rear fender fascia with LED tail light is built for 2009-2013 Harley Street Glide, Road Glide, and Electra Glide models that need a finished lower rear fender panel. The fascia covers the area between the fender and the saddlebags while housing a slim LED tail light for running and brake visibility. It suits riders replacing damaged factory trim or refreshing the rear end of a bagger build.

Built For Performance

• Integrated LED tail light provides running and brake illumination in one unit
• Molded fascia follows the factory rear fender contour for a flush fit
• Weather-resistant housing helps protect the LED board from road spray
• Bolt-on mounting uses the factory fascia attachment points
• Low-profile design keeps the rear end clean without bulky add-on lights

Fits These Machines

• for Harley Street Glide 2009-2013
• for Harley Road Glide 2009-2013
• for Harley Electra Glide 2009-2013
• for Harley Ultra Classic 2009-2013
• for Harley Road King 2009-2013

On-The-Job Use

• Replacing a cracked or missing factory rear fascia
• Finishing the rear fender after saddlebag or fender removal
• Daily riding and long-distance touring
• Custom bagger rear-end styling

Specs At A Glance

Good To Know

Q: Does this fascia come with mounting hardware? A: The listing covers the fascia and its integrated LED tail light, so check whether your factory bolts and clips are reusable before install. Most 2009-2013 Touring models can reuse the original hardware.

Q: Will the LED tail light work with my stock wiring? A: The tail light is designed for running and brake functions, but plug type and flasher behavior can vary, so verify your connectors before ordering. Some bikes may need a load equalizer.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.