Rear LED Turn Signals Light Bracket For Harley Sportster XL 883 1200 1992-2022

Rear LED Turn Signals Light Bracket for Harley Sportster XL 883 1200

This rear LED turn signals light bracket set is a direct-fit lighting and mounting solution that replaces worn or missing rear signal hardware on Harley Sportster XL 883 and 1200 models, giving your bike clean, bright rear indication with a sturdy bracket that holds each signal firmly in place.

Overview

This rear LED turn signals light bracket is made for riders who want reliable rear lighting on their Harley Sportster XL 883 or 1200. The kit pairs LED signal lamps with a mounting bracket so the lights sit secure and stay visible from behind. It is a straightforward replacement for damaged or dull factory rear signals and works as a practical refresh for the tail end of your Sportster.

Built For Performance

• LED lamps draw less current than incandescent bulbs and put less strain on the charging system.
• Bracket construction holds each turn signal rigid against vibration on the road.
• Bright LED output improves how easily other drivers spot your signal from behind.
• Designed as a rear position fit for Sportster XL 883 and 1200 models from 1992 through 2022.
• Simple bolt-on style mounting that follows the factory rear signal location.

Fits These Machines

• for Harley Sportster XL 883
• for Harley Sportster XL 1200
• for Harley Sportster XL 883 models from 1992 to 2022
• for Harley Sportster XL 1200 models from 1992 to 2022

On-The-Job Use

• Replacing cracked or missing rear turn signal housings on a Sportster.
• Refreshing the rear lighting on older XL 883 and 1200 models.
• Restoring rear signal function after a tip-over or minor spill.
• Updating the rear of the bike with LED illumination for daily riding.

Specs At A Glance

Good To Know

Q: Will these fit my Sportster if it is a 2005 XL 1200? A: The listing covers XL 883 and 1200 models from 1992 to 2022, so a 2005 XL 1200 falls within that range. Confirm your exact model and year before ordering.

Q: Do these LED signals need any extra parts? A: LED turn signals can sometimes need a load resistor or LED flasher relay to blink at the normal rate depending on your bike. Check your setup before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.