Rear Left & Right CV Axle Shaft w/ Bearing For Suzuki King Quad 450 500 700 750

Rear Left & Right CV Axle Shaft with Bearing for Suzuki King Quad 450 500 700 750

This rear left and right CV axle shaft with bearing set is a direct replacement assembly that restores power transfer to the rear wheels so your quad tracks straight under load. The constant velocity axle shafts for Suzuki King Quad 450, 500, 700, and 750 models ship as a matched left and right pair with bearings already pressed in place, cutting downtime during a rear driveline rebuild. Included bearings reduce the guesswork and extra sourcing that comes with a worn joint.

Overview

This rear CV axle shaft with bearing set is a bolt-on driveline replacement for Suzuki King Quad 450, 500, 700, and 750 machines. Each CV axle shaft with bearing is built to transfer torque smoothly from the rear differential to the wheel hub, correcting the vibration, clicks, and slack that come from a failed joint. It is intended for riders and shops doing a full rear left and right CV axle replacement.

Built For Performance

• Rear left and right CV axle shafts sold as a matched pair for balanced driveline operation
• Bearings pre-installed on both axle shafts to simplify the install
• Heat-treated steel construction for dependable torque handling on four-wheel-drive quads
• Fully assembled constant velocity joints with protective boots sealed against dirt and water
• Machined splines and mounting surfaces for a consistent fit at the differential and hub
• Corrosion-resistant finish that holds up to mud, trail spray, and repeated washdowns

Fits These Machines

• for Suzuki King Quad 450
• for Suzuki King Quad 500
• for Suzuki King Quad 700
• for Suzuki King Quad 750

On-The-Job Use

• Rear driveline rebuilds on four-wheel-drive utility quads
• Trail and mud riding where rear axles take constant shock loads
• Farm and ranch chores that keep the rear wheels under load
• Recovery and towing work that stresses the rear driveline
• Servicing a quad with torn boots or a clicking rear joint

Specs At A Glance

Good To Know

Q: Do I need to buy bearings separately? A: No. The bearings are already fitted to each axle shaft in this set, so you can install the pair without ordering extra hardware. Reuse the original mounting fasteners only if they are in good condition.

Q: Can I replace just one side? A: You can, but this set covers both rear sides, which is often the better call once one CV joint fails. Replacing the pair at the same time helps keep rear axle wear even.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.