Rear Shock Absorber Struts For 16-24 Chevrolet Camaro 23281657 85649835 23281658

Rear Shock Absorber Struts for Chevrolet Camaro

This pair of rear shock absorber struts is engineered to replace the original dampers on 2016 through 2024 Chevrolet Camaro models, cross-referencing OEM numbers 23281657, 85649835, and 23281658.

Overview

These rear shock absorber struts for Chevrolet Camaro deliver the damping control needed to keep the rear end planted through corners and stable over rough pavement. Each unit is built to match the valving and mounting geometry of the factory struts, making them a direct-fit replacement for worn or leaking originals. They suit daily drivers, weekend enthusiasts, and anyone restoring proper ride quality to a sixth-generation Camaro.

Built For Performance

• Gas-charged design resists heat fade during repeated compression cycles
• Precision valving tuned to match factory damping rates
• Heavy-gauge steel body with corrosion-resistant finish
• Hardened piston rod for long service life
• Direct-fit mounting points match original strut geometry
• Sold as a rear pair for balanced left and right performance

Fits These Machines

• for Chevrolet Camaro 2016
• for Chevrolet Camaro 2017
• for Chevrolet Camaro 2018
• for Chevrolet Camaro 2019
• for Chevrolet Camaro 2020
• for Chevrolet Camaro 2021
• for Chevrolet Camaro 2022
• for Chevrolet Camaro 2023
• for Chevrolet Camaro 2024

On-The-Job Use

• Restoring factory ride control on a high-mileage Camaro
• Replacing leaking or blown rear dampers after inspection
• Supporting predictable handling during spirited driving
• Maintaining stability with passengers or cargo in the rear

Specs At A Glance

Good To Know

Q: Do these struts fit both the left and right rear sides? A: Yes, this listing covers a rear pair so both sides of the vehicle are serviced at once. Always confirm your Camaro's trim and suspension package before ordering.

Q: Should rear struts be replaced in pairs? A: Replacing both rear struts together keeps damping balanced across the axle. Mixing a new unit with a worn one can cause uneven handling.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.