Rear Stabilizer Bar W/ Bushing For For Polaris RZR 4 800 EFI 2010-2014 825mm

Rear Stabilizer Bar with Bushing for Polaris

This rear stabilizer bar with bushing is an anti-roll replacement for Polaris RZR 4 800 EFI models from 2010 through 2014, measuring 825mm and built to cut rear body roll during turns.

Overview

This rear stabilizer bar with bushing is a direct replacement anti-roll component for Polaris RZR 4 800 EFI side-by-sides from 2010 to 2014. The stabilizer bar ties the rear suspension together so the chassis leans less in corners and stays flatter over rough ground. It is aimed at owners replacing a bent, rusted, or missing factory bar on a well-used machine.

Built For Performance

• 825mm length matched to the rear suspension of the RZR 4 800 EFI
• Supplied with a bushing for the mounting point
• Solid bar resists twisting under cornering load
• Protective finish guards against rust from mud and wash water
• Bolt-on replacement for the factory rear bar

Fits These Machines

• for Polaris RZR 4 800 EFI 2010
• for Polaris RZR 4 800 EFI 2011
• for Polaris RZR 4 800 EFI 2012
• for Polaris RZR 4 800 EFI 2013
• for Polaris RZR 4 800 EFI 2014

On-The-Job Use

• Rebuilding the rear suspension on a used RZR 4 800 EFI
• Trail and dune riding where rear lean is noticeable
• Replacing a bar damaged by impact or corrosion
• Keeping the rear end stable with passengers aboard

Specs At A Glance

Good To Know

Q: Is the bushing included with the bar? A: Yes, this listing pairs the rear stabilizer bar with a bushing for the mount, though you should check your existing hardware for wear before reuse.

Q: Can this bar be used on a two-seat RZR 800? A: It is listed for the RZR 4 800 EFI four-seat platform, and the longer wheelbase means a two-seat machine may take a different bar length.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.