Rear Sway Stabilizer Bar Tube W/Bushing Fit For RZR 4 800 / S 800 EFI 2010-2014

Rear Sway Stabilizer Bar for Polaris RZR 4 800 and S 800 EFI

This rear sway stabilizer bar tube with bushing is a direct-fit suspension component that reduces body roll and keeps the rear end planted on RZR 4 800 and S 800 EFI machines.

Overview

This rear sway stabilizer bar tube with bushing is built to control rear suspension articulation on RZR 4 800 and S 800 EFI models from 2010 through 2014. The stabilizer bar links the rear control arms to limit side-to-side lean through corners and off-camber terrain. It is a practical replacement for a bent, rusted, or worn factory bar on trail and utility machines.

Built For Performance

• Solid steel stabilizer bar tube resists flex under hard cornering loads
• Included bushing cushions the bar to reduce noise and vibration
• Direct-fit geometry matches the factory mounting points on RZR 4 800 and S 800 EFI
• Corrosion-resistant finish helps the bar hold up to mud, water, and trail debris
• Restores factory rear roll stiffness for more predictable handling

Fits These Machines

• for Polaris RZR 4 800 2010-2014
• for Polaris RZR S 800 EFI 2010-2014

On-The-Job Use

• Trail riding where rear body roll needs to be kept in check
• Rock crawling and off-camber sections that load the rear suspension
• Utility and farm work where the machine carries loads at the rear
• Replacing a bent or worn factory sway bar after impact damage

Specs At A Glance

Good To Know

Q: Does this bar come with the bushing? A: Yes, the rear sway stabilizer bar tube is supplied with its bushing as listed. Reuse your existing mounting hardware unless it shows damage.

Q: Will this fit both the RZR 4 800 and the S 800 EFI? A: It is listed for RZR 4 800 and S 800 EFI models from 2010 to 2014. Confirm your model and year before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.