Red Aluminum Car Battery Tie Down Mount Bracket Brace Bar & 10 Inch J-Bolts

Red Aluminum Battery Tie Down Bracket and 10 Inch J-Bolts

This red aluminum battery tie down bracket with 10 inch J-bolts secures a standard car battery in its tray to stop shifting and vibration.

Overview

This red aluminum car battery tie down mount bracket and 10 inch J-bolts kit holds a battery firmly in place inside the tray. The bracket spans the top of the battery while the J-bolts hook under the tray edge and tighten down. It suits drivers and builders who want a clean, corrosion-resistant hold-down for a daily driver, project car, or race build.

Built For Performance

• Aluminum construction resists corrosion better than plain steel hardware
• Anodized red finish adds a clean look under the hood
• Lightweight compared to a solid steel hold-down bar
• Includes two 10 inch J-bolts for a complete mounting setup
• Bracket bar spreads load across the top of the battery case

On-The-Job Use

• Securing a battery in a street or project car
• Replacing a rusted or missing factory hold-down
• Finishing off a custom engine bay build
• Keeping a battery stable during hard cornering or rough roads

Specs At A Glance

Good To Know

Q: Will this fit my battery tray? A: It is built around standard automotive battery tray layouts, so measure your tray width and battery height before ordering. J-bolt length can be trimmed if needed.

Q: Do the J-bolts come with nuts? A: This kit is sold as the bracket bar with its 10 inch J-bolts. Check your tray for the correct nut and washer fit during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.