Red Turbo Intercooler Pipe Boot Kit CAC Tubes for 2003-07 Ford 6.0L Powerstroke

Turbo Intercooler Pipe Boot Kit for Ford 6.0L Powerstroke

This red turbo intercooler pipe boot kit with CAC tubes replaces worn or leaking charge air cooler hoses on 2003-07 Ford 6.0L Powerstroke trucks, restoring a sealed path for boost to reach the engine.

Overview

This turbo intercooler pipe boot kit is built to replace cracked, swollen, or leaking boots on the charge air cooler system of 2003-07 Ford 6.0L Powerstroke diesel trucks. The CAC tubes and boots in this kit seal the intercooler pipe connections so pressurized air stays in the system instead of escaping, which helps restore lost power and throttle response. It is a direct-fit option for owners and shops servicing aging Ford 6.0L Powerstroke intercooler plumbing.

Built For Performance

• Red silicone boots resist heat, oil, and boost pressure better than factory rubber
• Charge air cooler tubes sized for the 2003-07 Ford 6.0L Powerstroke intercooler layout
• Reinforced construction holds up under repeated boost cycles
• Complete boot kit with CAC tubes for servicing the intercooler pipe connections in one job
• Red finish makes leak points easier to spot during inspection

Fits These Machines

• for Ford F-250 Super Duty 6.0L Powerstroke 2003-2007
• for Ford F-350 Super Duty 6.0L Powerstroke 2003-2007
• for Ford F-450 Super Duty 6.0L Powerstroke 2003-2007
• for Ford F-550 Super Duty 6.0L Powerstroke 2003-2007
• for Ford Excursion 6.0L Powerstroke 2003-2005

On-The-Job Use

• Replacing blown or leaking intercooler boots on high-mileage 6.0L Powerstroke trucks
• Restoring boost pressure after a boot failure causes low power or excessive smoke
• Routine charge air cooler maintenance during turbo or intake service
• Shop repairs on Ford Super Duty diesel pickups used for towing and hauling

Specs At A Glance

Good To Know

Q: Will this kit fit my 2004 Ford F-250 6.0L Powerstroke? A: This kit is listed for 2003-07 Ford 6.0L Powerstroke applications, and fit can vary by cab, bed, and intercooler configuration. Confirm your truck's specific intercooler pipe layout before ordering.

Q: Do I need to replace the boots and tubes together? A: Replacing the boots and CAC tubes as a set helps avoid a second repair when the remaining original parts fail under boost. Inspect the intercooler and clamps at the same time for a complete job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.