Replaces for Garmin NMEA 2000 Starter Kit, 010-11442-00

NMEA 2000 Starter Kit for Garmin

This NMEA 2000 starter kit replaces the original network components for Garmin marine electronics, cross-referencing part number 010-11442-00, and it provides the backbone cabling and connectors needed to link compatible devices on a single network.

Overview

This NMEA 2000 starter kit gives boaters the core network hardware to connect chartplotters, sonar modules, and engine data displays. Built as a replacement for Garmin systems, the kit carries the 010-11442-00 cross-reference so you can match it against your existing setup. It suits DIY installers and marine techs wiring a fresh NMEA 2000 backbone or replacing damaged cabling.

Built For Performance

• Backbone cable and drop connectors for a complete NMEA 2000 network run
• Cross-references part number 010-11442-00 for straightforward matching
• Terminators and tee connectors included for proper bus termination
• Corrosion-resistant contacts suited to the marine environment
• Standard NMEA 2000 connectors for broad device compatibility

Fits These Machines

• for Garmin chartplotters with NMEA 2000 ports
• for Garmin sonar and fish finder displays
• for Garmin autopilot and instrument systems

On-The-Job Use

• Wiring a new NMEA 2000 backbone on center consoles and cabin boats
• Replacing damaged or corroded network cabling
• Adding engine data and fuel flow monitors to an existing network
• Extending a network run to a second helm station

Specs At A Glance

Good To Know

Q: Do I need terminators at both ends of the network? A: Yes, a proper NMEA 2000 backbone requires a terminator at each end of the bus to work reliably. This starter kit supplies the terminator hardware needed for a complete run.

Q: Can I connect non-Garmin devices to this network? A: Any device with a standard NMEA 2000 connector can join the backbone, though configuration menus differ by brand. The kit itself is a direct replacement for the Garmin 010-11442-00 starter setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.