RH LH Mounting Bracket Plate GXH24760 GXH24761 Fit John Deere LA115 LA120 LA125

RH LH Mounting Bracket Plate for John Deere

The RH LH mounting bracket plate (OEM cross-reference GXH24760, GXH24761) replaces worn or broken deck or frame brackets, providing a secure mounting point for key components on select John Deere lawn tractors. This pair of mounting bracket plates ensures precise alignment and stable attachment for continued mowing performance.

Overview

This right-hand and left-hand mounting bracket plate set, carrying part numbers GXH24760 and GXH24761, is built to hold critical chassis or deck elements firmly in place for John Deere LA series tractors. The mounting bracket plate pair mirrors original factory geometry for a direct swap without modification. Each bracket plate uses heavy-duty construction to handle the stresses of regular lawn care.

Built For Performance

• Stamped steel construction offers high strength and resistance to bending.
• Pair includes RH plate (GXH24760) and LH plate (GXH24761) for complete replacement.
• Factory-matched hole spacing enables bolt-on installation.
• Protective coating resists rust and corrosion from grass clippings and moisture.
• Built to maintain tight, vibration-free mounting of adjacent parts.

Fits These Machines

• for John Deere LA115
• for John Deere LA120
• for John Deere LA125

On-The-Job Use

• Replaces cracked or deformed brackets during deck service or suspension repair.
• Restores secure attachment points for deck hangers or frame braces.
• Suited for routine maintenance on residential John Deere tractors with moderate acreage.

Specs At A Glance

Good To Know

Q: Are the GXH24760 and GXH24761 brackets the same as the ones on my LA120?
A: These plates match the original RH and LH mounting bracket plates referenced by those part numbers for the LA115, LA120, and LA125. Verify your tractor's serial number to confirm interchangeability.

Q: What is the best way to install these mounting bracket plates?
A: Clean the mating surface, position each bracket against the original mounting holes, and torque the fasteners to factory specifications. Replacing both sides at once is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.