Right Front Brake Master Cylinder Lever 7/8" 22MM for Suzuki GN125 GS125 GN250

Right Front Brake Master Cylinder Lever for Suzuki GN125 GS125 GN250

This 7/8 inch (22MM) right front brake master cylinder lever replaces the hand lever on the handlebar-mounted brake master cylinder, letting riders apply front braking pressure with a firm, consistent pull. The lever fits 22MM handlebars and is a direct replacement for worn or bent levers on compatible machines.

Overview

This right front brake master cylinder lever is a handlebar-mounted brake lever sized for 7/8 inch (22MM) bars. It pivots at the master cylinder to push the piston and apply front braking force. It suits riders replacing a bent, worn, or broken front brake lever on compatible motorcycles.

Built For Performance

• 7/8 inch (22MM) clamp size for standard handlebar fitment
• Right side, front brake master cylinder position
• Lever blade shaped for a controlled one or two finger pull
• Pivot bore sized to engage the master cylinder piston
• Metal construction with a smooth surface finish
• Direct replacement for the original lever shape

Fits These Machines

• for Suzuki GN125
• for Suzuki GS125
• for Suzuki GN250

On-The-Job Use

• Replacing a lever bent in a tip-over or drop
• Restoring front brake control after crash repair
• Routine replacement of a worn or loose brake lever
• Keeping a spare lever on hand for track or trail days

Specs At A Glance

Good To Know

Q: Does this lever work on either side of the handlebar? A: This is a right side front brake master cylinder lever only, sized for 7/8 inch (22MM) bars. The left clutch side requires a different lever.

Q: Can I install this lever without bleeding the brakes? A: Swapping the lever itself does not open the hydraulic circuit, so bleeding is normally not required. Check that the pivot bolt and piston contact seat correctly after fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.