Rubber Block for Volvo Penta Engines Suspension 876596 843323 Orbitrade 22323

Suspension Rubber Block for Volvo Penta Engines

This rubber block for Volvo Penta engine suspension replaces OEM part numbers 876596 and 843323, and is cross-referenced for Orbitrade 22323.

Overview

This rubber block for Volvo Penta engine suspension is a direct replacement for OEM part numbers 876596 and 843323, including cross-reference for Orbitrade 22323. The rubber block absorbs vibration and helps keep the engine aligned in its mount system. It is built for Volvo Penta engines that use a rubber suspension block to reduce transmitted motion.

Built For Performance

• Preformed rubber construction matches the original engine mount profile
• Absorbs vibration and dampens shock loads in the engine mounting system
• Direct replacement for Volvo Penta suspension block applications
• Marine-grade rubber resists corrosion and aging in wet environments
• Cross-references OEM numbers 876596, 843323, and is listed for Orbitrade 22323

On-The-Job Use

• Used as an engine mount block in Volvo Penta marine propulsion systems
• Supports the engine while minimizing vibration transfer to the hull
• Installed during engine alignment and mounting service procedures
• Helps maintain consistent engine position in the engine compartment

Specs At A Glance

Good To Know

Q: How does this rubber block mount? A: It sits between the engine and the mounting bracket to absorb vibration and maintain alignment. Confirm the locating holes and bracket pattern match your Volvo Penta engine before installation.

Q: Will this replace OEM 876596 and 843323? A: Yes, this rubber block is cross-referenced for 876596 and 843323, as well as for Orbitrade 22323. Fit can vary by serial number, so verification is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.