SB97495-50 Winch Remote Control For Smitty Bilt XRC Gen2 Series XRC8 XRC10 XRC1

Winch Remote Control for Smitty Bilt XRC Gen2 Series

This winch remote control replaces the hand controller on Smitty Bilt XRC Gen2 series winches, referencing part number SB97495-50, and lets you run the winch in and out from outside the cab.

Overview

This winch remote control is a replacement hand controller built for Smitty Bilt XRC Gen2 series winches, including XRC8, XRC10, and XRC12 models. It plugs into the winch control socket and gives you push-button power in and power out control from a safe distance. This winch remote control is aimed at truck and Jeep owners replacing a lost or worn hand controller on the trail.

Built For Performance

• Direct replacement for the Smitty Bilt XRC Gen2 hand controller, part number SB97495-50
• Controls winch power in and power out from a handheld position
• Plug-in connector matches the XRC Gen2 control socket for a tool-free swap
• Coiled cable keeps the lead tidy between the winch and the operator
• Molded housing grips well with gloves on

Fits These Machines

• for Smitty Bilt XRC8 Gen2 Series
• for Smitty Bilt XRC10 Gen2 Series
• for Smitty Bilt XRC12 Gen2 Series

On-The-Job Use

• Trail recovery pulls on a stuck truck or Jeep
• Loading and unloading vehicles on a trailer
• Yard and farm work pulling logs or fencing
• Keeping the operator away from a taut winch line

Specs At A Glance

Good To Know

Q: Will this work on a first-generation XRC winch? A: It is listed for the Gen2 series XRC8, XRC10, and XRC12, so confirm your winch generation before ordering. Q: Do I need any extra wiring? A: The remote plugs into the existing winch control socket, so no additional harness is normally required.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.