Silver 7/8" Front Brake Master Cylinder for Honda FourTrax 300 TRX300 1988-2000
Silver 7/8" Front Brake Master Cylinder for Honda FourTrax 300 TRX300 1988-2000
Couldn't load pickup availability
7/8" Front Brake Master Cylinder for Honda
This silver 7/8 inch front brake master cylinder replaces the handlebar-mounted brake control on Honda FourTrax 300 TRX300 models from 1988 through 2000.
Overview
This front brake master cylinder mounts on a 7/8 inch handlebar and translates lever pressure into hydraulic braking force. It is built as a replacement for the FourTrax 300 TRX300, restoring reliable front brake response. Riders and mechanics servicing older Honda ATVs will find this front brake master cylinder a practical fix for a worn or leaking unit.
Built For Performance
- Fits 7/8 inch handlebars common to the listed Honda ATVs
- Silver finish that matches typical factory handlebar controls
- Single-lever front brake master cylinder design
- Built to hold hydraulic pressure for consistent brake feel
- Replaces a failed or worn original master cylinder
Fits These Machines
- for Honda FourTrax 300 TRX300 1988
- for Honda FourTrax 300 TRX300 1989
- for Honda FourTrax 300 TRX300 1990
- for Honda FourTrax 300 TRX300 1991
- for Honda FourTrax 300 TRX300 1992
- for Honda FourTrax 300 TRX300 1993
- for Honda FourTrax 300 TRX300 1994
- for Honda FourTrax 300 TRX300 1995
- for Honda FourTrax 300 TRX300 1996
- for Honda FourTrax 300 TRX300 1997
- for Honda FourTrax 300 TRX300 1998
- for Honda FourTrax 300 TRX300 1999
- for Honda FourTrax 300 TRX300 2000
On-The-Job Use
- Restoring front brake control on older FourTrax ATVs
- Farm and utility work where dependable brakes are essential
- Trail riding on legacy Honda machines
- Routine hydraulic brake servicing
Specs At A Glance
| Part Type | Front Brake Master Cylinder |
| Handlebar Size | 7/8 inch |
| Color | Silver |
| Position | Front |
Good To Know
Q: Do I need to bleed the brakes after installing this master cylinder? A: Yes, bleeding the front brake system is required to remove air and restore firm lever feel. Follow the service procedure for your Honda TRX300.
Q: Is this a complete bolt-on unit? A: This listing covers the front brake master cylinder itself. Reuse or replace the lever and hardware as needed, and verify the 7/8 inch bar fit before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
