Standard Bore Cylinder Jug for 2014-2025 Yamaha Viking 700 YXM700D YXM700P 4x4

Standard Bore Cylinder Jug for Yamaha Viking 700

This Standard Bore Cylinder Jug is a replacement top-end cylinder for Yamaha Viking 700 models, providing the bore surface the piston and rings ride against to restore compression.

Overview

This Standard Bore Cylinder Jug is the top-end cylinder that houses the piston and forms the combustion chamber on a Yamaha Viking 700. It provides a fresh, correctly sized bore surface so the piston and rings can seal and build compression again. It is intended for riders rebuilding a worn or scored top end to factory bore size.

Built For Performance

• Standard bore sizing to match the original piston and rings
• Cast construction with machined bore surface for ring sealing
• Cooling passages sized to match the factory cylinder
• Direct replacement for a scored or worn original jug
• Bolt-on mounting pattern that matches the engine case

Fits These Machines

• for Yamaha Viking 700 YXM700D 4x4
• for Yamaha Viking 700 YXM700P 4x4

On-The-Job Use

• Top-end rebuild after a scored or worn cylinder
• Restoring compression on a high-hour engine
• Replacing a jug damaged by piston seizure
• Routine engine service on a Yamaha Viking 700

Specs At A Glance

Good To Know

Q: Do I need new rings and a piston with this jug? A: A fresh bore is typically paired with new rings, and often a new piston, to get a proper seal and full compression. Q: Is this sold as a complete top-end kit? A: This listing is for the cylinder jug itself, so check whether gaskets, piston, and rings are included before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.