Steering Rack And Pinion Boot Kit for Polaris RZR 570 2012 2013 2014 2015-2018

Steering Rack and Pinion Boot Kit for Polaris RZR 570

This steering rack and pinion boot kit for Polaris RZR 570 models covers the rack ends to keep dust, water, and mud out of the pinion area and preserve smooth steering response.

Overview

This steering rack and pinion boot kit for Polaris RZR 570 supplies boots that seal the steering rack where it meets the tie rods. The boots hold grease at the rack ends and block the grit that wears rack gears and bushings. It is made for RZR 570 owners handling routine steering upkeep and replacement of torn or cracked boots.

Built For Performance

• Rubber boots sized for the RZR 570 rack and pinion assembly
• Resists cracking from heat, trail mud, and sun exposure
• Seals rack ends to keep lubricant in place
• Replaces dried or split factory boots during rack service
• Works with standard rack grease for periodic maintenance

Fits These Machines

• for Polaris RZR 570 2012
• for Polaris RZR 570 2013
• for Polaris RZR 570 2014
• for Polaris RZR 570 2015
• for Polaris RZR 570 2016
• for Polaris RZR 570 2017
• for Polaris RZR 570 2018

On-The-Job Use

• Trail and dune riding where the rack sees constant debris
• Routine rack service after grease inspection
• Replacing boots torn by sticks, rocks, or brush
• Keeping older RZR 570 steering feeling tight

Specs At A Glance

Good To Know

Q: Are clamps or hardware included with this kit? A: The listing does not confirm included clamps, so verify contents before ordering. Factory or aftermarket clamps can be used during installation.

Q: Why replace the rack boots on a RZR 570? A: Split or loose boots let water and grit reach the rack gears and cause premature wear. New boots keep grease sealed in and debris out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.