TC422-39700 Adjustable Turnbuckle Stabilizer for Kubota L3800DT L3800H L3800F

Adjustable Turnbuckle Stabilizer for Kubota

This adjustable turnbuckle stabilizer is a replacement side link for the three-point hitch, designed to eliminate implement sway and maintain alignment. Built for Kubota L3800 series tractors, it references OEM cross-reference number TC422-39700.

Overview

This adjustable turnbuckle stabilizer for Kubota L3800DT, L3800H, and L3800F tractors replaces the original turnbuckle link to keep mounted implements centered and stable. The adjustable design lets you fine-tune the link length for a precise fit with various category 1 attachments. This stabilizer restores factory-level support and control to the hitch system.

Built For Performance

• Threaded turnbuckle shaft allows fine length adjustments without removing the link
• Heavy-duty steel body withstands stress from lifting and pulling
• Direct replacement for OEM part number TC422-39700
• Includes ball joints or clevis ends to fit standard hitch pins
• Maintains consistent implement tracking during tight turns

Fits These Machines

• for Kubota L3800DT
• for Kubota L3800H
• for Kubota L3800F

On-The-Job Use

• Secures post hole diggers and augers to prevent swinging
• Stabilizes grader blades and scrape blades for even cutting depth
• Reduces stress on lower link arms during heavy draft work
• Use with landscape rakes or rock rakes for steady operation

Specs At A Glance

Good To Know

Q: Is this the left or right side stabilizer? A: This is a universal pattern link for either side; check the orientation of the threaded ends and ball sockets to match your tractor's existing hardware.

Q: Can I use this with a quick hitch? A: Yes, as long as the quick hitch uses standard category 1 pin spacing, the turnbuckle will connect properly to the lift arms.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.