Throttle Cable Carb Bracket Carburetor 350 for Holley Aluminum 4150 4160 Series

Throttle Cable Carb Bracket Carburetor 350 for Holley Aluminum 4150 4160 Series

This aluminum throttle cable and carburetor bracket mounts to 350 style carburetors and works with Holley 4150 and 4160 series four-barrel units to hold the throttle cable squarely at the linkage.

Overview

This throttle cable carb bracket gives 4150 and 4160 series carburetors a solid mounting point for the throttle cable and return spring. The aluminum carburetor bracket fits Holley 350 style setups and keeps the cable lined up with the throttle lever for smooth, predictable pedal response. It is a straightforward piece for engine swaps, rebuilds, and throttle linkage cleanups.

Built For Performance

• Aluminum construction that resists corrosion
• Shaped to locate the throttle cable square to the linkage
• Mounting provision for a throttle return spring
• Designed around 4150 and 4160 series bolt patterns
• Compact footprint that clears common intake and fuel line routing

Fits These Machines

• for Holley 4150 series carburetors
• for Holley 4160 series carburetors
• 350 style carburetor applications

On-The-Job Use

• Engine swaps that need a throttle cable anchor
• Carburetor rebuilds where the original bracket is missing
• Throttle linkage cleanups on street and strip builds
• Return spring mounting on 4150 and 4160 set-ups

Specs At A Glance

Good To Know

Q: Will this bracket fit both 4150 and 4160 series carburetors? A: It is made for the 350 style pattern used across the Holley 4150 and 4160 series. Check your base plate bolt spacing before ordering.

Q: Does it include a return spring? A: The bracket provides the mounting point, but the spring and cable are not part of this listing. Add your own hardware after confirming the linkage layout.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.