Top End Rebuild Kit for Suzuki Eiger 400 King Quad 400 Cylinder Piston Gaskets

Top End Rebuild Kit for Suzuki Eiger 400 and King Quad 400

This top end rebuild kit for Suzuki Eiger 400 and King Quad 400 engines includes a cylinder, piston, and gasket set to restore compression and top end performance.

Overview

This top end rebuild kit for Suzuki Eiger 400 and King Quad 400 models supplies the cylinder, piston, and gaskets needed to refresh a worn or damaged top end. The kit serves riders and mechanics rebuilding an engine after loss of compression, overheating, or piston damage. Each top end rebuild kit component is intended to work together so the rebuild goes back together with matched parts.

Built For Performance

• Cylinder and piston matched as a set for consistent bore clearance
• Gasket kit included for sealing the top end during reassembly
• Suited to the 400cc single cylinder engine family
• Direct replacement for worn OEM top end components
• Handles normal trail and utility riding loads

Fits These Machines

• for Suzuki Eiger 400
• for Suzuki King Quad 400

On-The-Job Use

• Top end rebuild after low compression or smoking
• Engine refresh during routine maintenance
• Trail and utility ATV repair
• Workshop rebuild of a seized or overheated top end

Specs At A Glance

Good To Know

Q: Do I need to recheck valve clearance after installing this kit? A: Yes, valve clearance should be checked and reset after any top end rebuild. Refer to your service manual for the correct clearance values.

Q: Should the cylinder be honed or measured before installation? A: New kits are typically ready to install, but measuring piston to cylinder clearance is good practice. Confirm bore sizing against the piston before assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.