Transom Trolling Motor Mount for Kayaks - 3.75" x 4.75" Bolt Pattern - 6mm Thick

Transom Trolling Motor Mount for Kayaks

This transom trolling motor mount gives kayak anglers a sturdy, bolt-on platform for securing a trolling motor to the stern, featuring a 3.75" x 4.75" bolt pattern and 6mm thick construction.

Overview

This transom trolling motor mount is built to anchor a kayak trolling motor firmly at the stern so you can steer and fish hands-free. The 6mm thick plate resists flex under load, and the 3.75" x 4.75" bolt pattern lines up with many common motor brackets. It suits kayak anglers who want a dependable transom trolling motor mount without drilling custom holes.

Built For Performance

• 6mm thick material resists bending under motor torque
• 3.75" x 4.75" bolt pattern matches many standard motor brackets
• Flat transom plate spreads load across the mounting surface
• Drilled and ready for bolt-on installation
• Weather-exposed surface suited to fresh and saltwater use

On-The-Job Use

• Mounting a trolling motor to a kayak transom
• Trolling shorelines and weed edges at low speed
• Positioning and holding over structure while casting
• Replacing a cracked or flexing factory motor plate

Specs At A Glance

Good To Know

Q: Will this fit my kayak's trolling motor? A: Measure your motor bracket bolt spacing and compare it to the 3.75" x 4.75" pattern before ordering. Transom shape and thickness also affect fit.

Q: Do I need special hardware to install it? A: Use stainless steel bolts, washers, and lock nuts sized to your transom thickness to resist corrosion. Seal the holes with marine sealant to keep water out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.