Trim Sender 3 Wire for Penta TSK SX-M MDA Models 21652399 3858212

Trim Sender 3 Wire for Penta

This trim sender 3 wire for Penta monitors outdrive angle and sends a precise signal to the gauge, replacing OEM numbers 21652399 and 3858212.

Overview

The trim sender 3 wire for Penta is a rugged sensor that tracks the exact position of your outdrive for accurate trim readings. It fits Penta TSK, SX-M, and MDA models, and it directly replaces 21652399 and 3858212. This trim sender 3 wire ensures you know your boat's trim level at all times.

Built For Performance

• 3-wire design for reliable signal transmission
• Corrosion-resistant housing for marine environments
• Sealed connections prevent moisture intrusion
• Direct replacement for OEM 21652399 and 3858212
• Precision potentiometer for accurate angle sensing

Fits These Machines

• for Penta TSK
• for Penta SX-M
• for Penta MDA

On-The-Job Use

• Monitor trim angle while cruising
• Adjust outdrive for optimal fuel efficiency
• Verify trim level before trailering

Specs At A Glance

Good To Know

Q: How do I confirm this trim sender fits my Penta outdrive? A: Check your drive model against the listed TSK, SX-M, and MDA series, and verify your OEM part number matches 21652399 or 3858212.

Q: Is this an original Penta part? A: No, this is an aftermarket replacement built to meet OEM specifications for Penta applications.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.