Universal 3" Aluminum Intercooler Turbo Piping Kit Hose + Red Silicone + Clamp

Universal 3" Aluminum Intercooler Turbo Piping Kit

This universal 3 inch aluminum intercooler turbo piping kit includes the pipe sections, red silicone couplers, and clamps needed to build or replace a charge air system on a custom turbo setup.

Overview

This universal intercooler turbo piping kit gives builders a complete 3 inch charge pipe setup with red silicone couplers and clamps for a turbo build. The aluminum piping kit suits custom fabrication projects where no factory route exists. It is aimed at fabricators, drift and drag builders, and anyone assembling a turbo system from scratch.

Built For Performance

• 3 inch outside diameter aluminum pipe sections
• Red silicone couplers for high-temperature charge air connections
• Hose clamps included for securing each joint
• Universal layout suits custom charge pipe routing
• Aluminum construction keeps weight down compared to steel piping

On-The-Job Use

• Custom turbo and intercooler charge pipe fabrication
• Drift and drag car builds
• Diesel truck turbo system plumbing
• Replacing damaged or corroded factory charge pipes

Specs At A Glance

Good To Know

Q: Do I need to cut the pipes to fit my car? A: Yes, this is a universal kit and the pipes are typically cut and clocked to match your specific routing. Measure twice before trimming and test fit the couplers first.

Q: Are the silicone couplers rated for boost pressure? A: Silicone couplers handle normal boost levels found on most turbo builds when clamped properly. Use bead-rolled or flared pipe ends to prevent couplers from blowing off under high boost.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.