Upgraded Tierod Ends Kit 52-1004B for Yamaha YFZ450 YFZ450R YFZ450RSE YFZ450V

Tierod Ends Kit 52-1004B for Yamaha YFZ450

This tierod ends kit 52-1004B supplies replacement tie rod end assemblies for the steering linkage on select Yamaha YFZ450, YFZ450R, YFZ450RSE, and YFZ450V models, restoring precise steering response.

Overview

This tierod ends kit 52-1004B provides the tie rod end components needed to refresh the steering linkage on compatible Yamaha YFZ450 quads. The kit is referenced under part number 52-1004B and is intended to replace worn or damaged tierod ends that cause sloppy steering. It suits riders and mechanics rebuilding front-end geometry on YFZ450, YFZ450R, YFZ450RSE, and YFZ450V machines.

Built For Performance

• Direct replacement for worn factory tie rod ends
• Heavy-duty construction for off-road steering loads
• Threaded studs for toe adjustment during alignment
• Sold as a kit for both sides of the steering linkage
• Designed to restore tight, responsive steering feel

Fits These Machines

• for Yamaha YFZ450
• for Yamaha YFZ450R
• for Yamaha YFZ450RSE
• for Yamaha YFZ450V

On-The-Job Use

• Trail riding where rocks and ruts stress the front end
• Motocross and cross-country racing use
• Dune riding with heavy steering loads
• Routine front-end rebuilds and alignment service
• Repair after a collision or hard impact

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this tierod ends kit? A: Yes, toe setting should be checked and adjusted after installation to avoid uneven tire wear. A shop manual or alignment gauge helps dial in the correct spec.

Q: Is this kit a genuine Yamaha part? A: No, this is an aftermarket tierod ends kit referenced under 52-1004B that fits the listed Yamaha YFZ450 models. It is not an original Yamaha product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.