US Rear Brake Master Cylinder Pump For Suzuki GSXR 600 750 1000 1100 GSX1300R

Rear Brake Master Cylinder Pump for Suzuki GSXR 600 750 1000 1100 and GSX1300R

This rear brake master cylinder pump is a hydraulic assembly that pressurizes the rear brake circuit on Suzuki GSXR 600, 750, 1000, and 1100 sportbikes as well as the GSX1300R. It bolts to the rear brake pedal linkage and pushes fluid to the rear caliper for consistent stopping power. Built for riders and shops replacing a worn, leaking, or seized rear master cylinder.

Overview

This rear brake master cylinder pump is intended for Suzuki GSXR 600, 750, 1000, and 1100 models along with the GSX1300R. It converts pedal travel into hydraulic pressure at the rear caliper, restoring reliable rear brake feel. A practical replacement for riders servicing a leaking or unresponsive rear brake system on these sportbikes.

Built For Performance

• Rear master cylinder pump assembly for the rear hydraulic brake circuit
• Pedal-driven design matched to the rear brake linkage on listed GSXR and GSX1300R models
• Compact body layout that fits the rear-set mounting area
• Reservoir connection point for the rear brake fluid line
• Metal housing built to handle consistent hydraulic pressure
• Serviceable replacement for a failed or leaking rear master cylinder

Fits These Machines

• for Suzuki GSXR 600
• for Suzuki GSXR 750
• for Suzuki GSXR 1000
• for Suzuki GSXR 1100
• for Suzuki GSX1300R

On-The-Job Use

• Replacing a rear master cylinder that leaks or fails to build pressure
• Rebuilding the rear brake system on a sportbike project
• Restoring rear brake response after a track day or long storage
• Routine rear brake service on GSXR and GSX1300R models

Specs At A Glance

Good To Know

Q: Will this rear master cylinder pump fit my GSXR or GSX1300R? A: It is listed for Suzuki GSXR 600, 750, 1000, 1100, and GSX1300R models. Confirm your year and model variant match before ordering, since mounting points can vary.

Q: Does the rear brake need bleeding after installing this pump? A: Yes, the rear brake circuit must be bled after installation to remove trapped air and restore firm pedal feel. Use fresh brake fluid and top off the reservoir as you bleed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.