Water Pump Impeller 688-44352-03 18-3070 for Yamaha 2-Stroke 60HP 75HP 80HP 85HP

Water Pump Impeller for Yamaha

This water pump impeller for Yamaha 2-stroke outboard engines ensures efficient cooling for 60HP, 75HP, 80HP, and 85HP models, with OEM cross-reference numbers 688-44352-03 and 18-3070.

Overview

The water pump impeller is essential for drawing water through the cooling system, protecting your Yamaha 2-stroke engine from heat damage. Built for 60HP, 75HP, 80HP, and 85HP outboards, this impeller provides consistent water flow. Its robust rubber design resists wear and deformation, ensuring long-lasting performance.

Built For Performance

• Reinforced rubber construction for high durability
• Exact fit for Yamaha 2-stroke outboard models
• OEM cross-reference 688-44352-03 and 18-3070
• Advanced blade geometry maximizes water flow
• Simple installation with no special tools required
• Resistant to heat and chemical degradation

Fits These Machines

• for Yamaha 2-Stroke 60HP
• for Yamaha 2-Stroke 75HP
• for Yamaha 2-Stroke 80HP
• for Yamaha 2-Stroke 85HP

On-The-Job Use

• Replacing a cracked or worn impeller after seasons of use
• Ensuring proper engine cooling during high-speed runs
• Maintaining reliable performance in saltwater conditions
• Performing a complete water pump rebuild or preventive maintenance

Specs At A Glance

Good To Know

Q: What is the typical lifespan of a water pump impeller? A: Most manufacturers recommend replacement every 100 hours of operation or annually, as rubber can harden and lose flexibility over time.

Q: Can I install this impeller myself? A: Yes, the installation is straightforward with basic hand tools, but always consult your engine's service manual for specific torque specs and procedures.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.