Water Pump Impeller For Force 85, 90, 120, 125, 150HP 18-3017 F694065 47-89984

Water Pump Impeller for Force

This water pump impeller for Force 85, 90, 120, 125, and 150HP outboard motors replaces OEM references 18-3017, F694065, and 47-89984 to keep cooling water flowing through the engine.

Overview

The water pump impeller is the rotating component inside the outboard cooling system that pulls water through the intake and circulates it over the engine. This replacement water pump impeller is designed for select Force outboard motors, including 85, 90, 120, 125, and 150HP models. Use OEM cross-reference numbers 18-3017, F694065, and 47-89984 to confirm compatibility.

Built For Performance

• Replaces OEM part numbers 18-3017, F694065, and 47-89984
• Designed for Force 85, 90, 120, 125, and 150HP outboards
• Used in the lower unit water pump assembly
• Restores cooling water flow when the original impeller is worn or damaged

Fits These Machines

• for Force 85HP
• for Force 90HP
• for Force 120HP
• for Force 125HP
• for Force 150HP

On-The-Job Use

• Replacing a cracked or worn water pump impeller during outboard service
• Restoring cooling water flow in freshwater or saltwater boating
• Preventing overheating during long runs at high throttle
• Keeping fishing boats, runabouts, and workboats running cool

Specs At A Glance

Good To Know

Q: How often should a water pump impeller be inspected? A: Water pump impellers should be inspected every season or after about 100 hours of operation. Replacing a worn impeller helps avoid overheating damage.

Q: What happens if the impeller is not replaced? A: A worn impeller can reduce water flow and cause the engine to overheat. Replace it when you notice a weak tell-tale stream or higher engine temperature.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.