Wire Harness LH Driver Side For 09-14 Ford F150 Crew Cab REAR Door Jumper

Wire Harness LH Driver Side for Ford F150 Crew Cab REAR Door Jumper

This left hand driver side rear door jumper wire harness connects the door mounted electrical components of a 2009 to 2014 Ford F150 Crew Cab to the main body harness, restoring power and signal flow for locks, windows, and speakers.

Overview

This rear door jumper wire harness is built as a direct replacement for the left hand driver side rear door of a 2009 to 2014 Ford F150 Crew Cab. The jumper harness carries power and ground between the door and the body, so windows, locks, and speakers work as intended. It suits owners and technicians repairing damaged, corroded, or cut wiring on a Crew Cab F150.

Built For Performance

• Factory style connectors keyed for the left hand rear door on Ford F150 Crew Cab models
• Plug and play jumper design that mates with the body side harness without splicing
• Automotive grade wire insulation rated for vibration and temperature swings
• Protective loom and strain relief at flex points to resist chafing through the door jamb
• Direct replacement for a damaged or corroded rear door jumper harness

Fits These Machines

• for Ford F150 Crew Cab 2009
• for Ford F150 Crew Cab 2010
• for Ford F150 Crew Cab 2011
• for Ford F150 Crew Cab 2012
• for Ford F150 Crew Cab 2013
• for Ford F150 Crew Cab 2014

On-The-Job Use

• Restoring power to rear door windows and locks after a wiring failure
• Replacing a jumper harness damaged by water intrusion or corrosion in the door jamb
• Repairing speaker and accessory circuits in the left rear door
• Collision repair where the rear door harness was cut or stretched

Specs At A Glance

Good To Know

Q: Is this harness a direct fit for the left rear door? A: It is designed as a jumper harness for the left hand driver side rear door on 2009 to 2014 Ford F150 Crew Cab models. Confirm your cab configuration and door position before ordering.

Q: Do I need to splice any wires to install it? A: This is a jumper harness with factory style connectors, so it mates to the door and body harnesses without cutting or splicing. Route it through the door jamb boot and secure the loom.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.