X3 Cooling Radiator Fan Housing Assembly Kit For 17-25 Can-Am Maverick X3 & Max

Cooling Radiator Fan Housing Assembly Kit for Can-Am

This radiator fan housing assembly kit bolts in to move air across the cooling radiator on Can-Am Maverick X3 and Max models from 2017 through 2025, helping the engine hold steady temperatures under hard use.

Overview

This cooling radiator fan housing assembly kit is built to replace a worn or damaged fan and shroud on the Can-Am Maverick X3 and Max platform. The radiator fan housing assembly kit restores airflow through the radiator core, which keeps coolant temperatures in check during trail rides and dune runs. It suits riders who want a direct-fit cooling component for their side-by-side without hunting down individual pieces.

Built For Performance

• Complete fan and housing assembly designed for the Can-Am Maverick X3 cooling system
• Shroud directs airflow through the radiator core instead of letting it escape around the edges
• Fan blade profile engineered to pull strong CFM at low and high engine speeds
• Housing mounts to factory radiator mounting points without custom fabrication
• Construction suited to the heat, dust, and vibration of off-road use
• Assembly kit includes the fan and housing components needed for the job

Fits These Machines

• for Can-Am Maverick X3 (2017-2025)
• for Can-Am Maverick X3 Max (2017-2025)

On-The-Job Use

• Trail riding where slow speeds and low airflow stress the cooling system
• Dune and desert running in high ambient temperatures
• Mud and brush conditions that pack debris into the radiator and shroud
• Replacing a cracked shroud or seized fan after a hard season

Specs At A Glance

Good To Know

Q: Will this fit both the two-seat and four-seat Maverick X3? A: The kit is listed for the Maverick X3 and X3 Max across the 2017 to 2025 range, so confirm your exact model year and trim before ordering.

Q: Do I need any extra hardware to install this fan housing kit? A: It mounts using the factory radiator mounting points, so reusing your existing fasteners is normally all that is required.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.