010-10551-00 Marine Network Cable 20 Feet with Split Connector & Waterproof Cap

010-10551-00 Marine Network Cable 20 Feet with Split Connector & Waterproof Cap

This 20 foot marine network cable is a replacement for 010-10551-00, carrying data between compatible marine electronics with a split connector and a waterproof cap protecting the exposed end.

Overview

This 20 foot marine network cable is built to link compatible marine electronics into a working network backbone. The split connector lets it tie into an existing run, while the waterproof cap seals the unused port against spray and moisture. Suited to boat owners extending or repairing a network run on board.

Built For Performance

• 20 foot length gives reach across a typical helm or console layout
• Split connector allows branching into an existing network run
• Waterproof cap seals the open connector against moisture and spray
• Direct replacement for part number 010-10551-00
• Marine-grade jacket built for the damp, vibration-prone onboard environment

On-The-Job Use

• Extending a marine network run between helm and console electronics
• Replacing a damaged or corroded network cable on board
• Adding a split connection point to an existing network backbone

Specs At A Glance

Good To Know

Q: Will this cable work with any marine network device? A: It is intended as a replacement for marine network equipment that accepts the 010-10551-00 cable and its split connector configuration.

Q: Why does the cable come with a waterproof cap? A: The cap covers the open connector when the split port is unused, keeping moisture and salt spray out of the exposed contacts.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.