03.1322 Pro-X Connecting Rod Kit for Honda CR250R CR 250R 2002-2007

Connecting Rod Kit for Honda CR250R

The Pro-X Connecting Rod Kit rebuilds the crankshaft assembly on the Honda CR250R, restoring the crank with a hardened rod, lower bearing, and crank pin.

Overview

This Pro-X Connecting Rod Kit is a complete crankshaft rebuild solution for the Honda CR250R. The kit pairs a hardened connecting rod with a lower rod bearing and crank pin so the bottom end can be serviced rather than replaced. Riders rebuilding a tired or seized CR250R bottom end get the critical parts for a proper crank refresh in one set.

Built For Performance

• Hardened steel connecting rod built for two-stroke rpm
• Includes lower rod bearing and crank pin for a full rebuild
• Precision-machined for correct big-end clearance
• Balanced for use with the factory crankshaft assembly
• Direct replacement for the original rod

Fits These Machines

• for Honda CR250R 2002
• for Honda CR250R 2003
• for Honda CR250R 2004
• for Honda CR250R 2005
• for Honda CR250R 2006
• for Honda CR250R 2007

On-The-Job Use

• Bottom-end rebuilds on CR250R engines
• Refreshing a worn or noisy crankshaft
• Motocross and off-road engine service
• Complete rebuild projects for two-stroke race bikes

Specs At A Glance

Good To Know

Q: Does this kit include the lower bearing and pin? A: Yes, this kit ships as a complete connecting rod assembly with the lower bearing and crank pin.

Q: Is crank pressing required for installation? A: Rod kits are normally pressed and trued into the crankshaft, so professional crank service is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.