03.2510P Pro-X Connecting Rod Kit for Yamaha Wave Raider 700 Deluxe 1994-2001

Pro-X Connecting Rod Kit for Yamaha Wave Raider 700/Deluxe

This Pro-X connecting rod kit is a crankshaft rebuild component for Yamaha Wave Raider 700 and Deluxe personal watercraft, restoring the rod-to-crankshaft assembly when the original rod wears or fails, and cross-references part number 03.2510P.

Overview

This Pro-X connecting rod kit for Yamaha Wave Raider 700/Deluxe delivers the rod assembly needed to rebuild a worn or damaged crankshaft in 1994-2001 models. The connecting rod kit suits riders and mechanics performing a top-to-bottom engine refresh on their Yamaha Wave Raider. Each kit is built to OEM-equivalent dimensions and carries the Pro-X 03.2510P part number for easy lookup.

Built For Performance

• Forged steel rod construction for high-rpm marine duty
• Precision-machined bearing surfaces for consistent fit
• Balanced rod weight to match OEM crankshaft specifications
• Includes rod, bearing, and pin for a complete rebuild position
• Heat-treated for resistance to the loads seen in two-stroke PWC engines
• Cross-reference part number 03.2510P for easy verification

Fits These Machines

• for Yamaha Wave Raider 700 (1994-2001)
• for Yamaha Wave Raider Deluxe (1994-2001)

On-The-Job Use

• Crankshaft rebuilds on Yamaha Wave Raider 700 and Deluxe models
• Top-end and bottom-end engine refreshes on 1994-2001 personal watercraft
• Replacing scored or seized connecting rods after lean-run damage
• Routine engine overhauls at the recommended service interval
• Shop and DIY rebuilds where OEM-equivalent parts are preferred

Specs At A Glance

Good To Know

Q: How many connecting rods come in this kit? A: This is a single connecting rod kit, so order the number of positions the crankshaft requires. Confirm the quantity needed for your Yamaha Wave Raider 700 or Deluxe rebuild before ordering.

Q: Does this kit include the rod bearing and wrist pin? A: The Pro-X 03.2510P kit is supplied as a complete rod assembly with the bearing and pin for that rod position. Match the part number to your crankshaft before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.