03.2510P Pro-X Connecting Rod Kit for Yamaha Wave Runner III GP 700 1994

Connecting Rod Kit for Yamaha Wave Runner III GP 700

This Pro-X connecting rod kit (03.2510P) supplies the rods and rod bearings required to rebuild the bottom end of your 1994 Yamaha Wave Runner III GP 700 engine.

Overview

This connecting rod kit is sold for the 1994 Yamaha Wave Runner III GP 700 and replaces worn or damaged rods in the 700cc engine. The Pro-X connecting rod kit keeps the crank-to-piston link intact, helping restore factory-like operation on the water. It is aimed at owners and shops doing a rebuild on this specific Wave Runner III GP 700 model.

Built For Performance

• Pro-X connecting rod kit matched to the Yamaha 700cc marine engine
• Rods sized for the 700cc GP crankcase
• Caged needle bearings for smooth rod-to-crank movement
• Includes rods and rod bearings for a bottom-end refresh
• Machined to OEM-spec dimensions for the 700cc engine

Fits These Machines

• for Yamaha Wave Runner III GP 700 (1994)

On-The-Job Use

• Bottom-end rebuilds on Wave Runner III GP 700 engines
• Replacing scored or seized connecting rods
• Refresh projects on 1994 GP 700 personal watercraft
• Shop and DIY repair when OEM rods are hard to source

Specs At A Glance

Good To Know

Q: Do I need to replace both rods at the same time? A: Yes, connecting rods should be replaced as a matched set so the crank stays balanced and both cylinders share the same rod geometry.

Q: Does this kit include everything for a bottom-end rebuild? A: It includes the rods and related rod components shown, but gaskets, seals, and crank bearings are typically ordered separately for a complete rebuild.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.