03.6427 Pro-X Connecting Rod Kit for KTM XC-F 450 2008-2009 XC-F450

Connecting Rod Kit for KTM XC-F 450

This Pro-X connecting rod kit is a direct replacement component for the 2008-2009 KTM XC-F 450, designed to restore proper crank assembly geometry and endure the stresses of off-road four-stroke operation.

Overview

This connecting rod kit for KTM XC-F 450 provides the rod, bearing, and related hardware needed to rebuild your engine's bottom end. The Pro-X connecting rod kit for KTM XC-F 450 is built to OEM-equivalent tolerances so it drops into the stock crank assembly. It suits riders and mechanics handling a top-to-bottom four-stroke rebuild.

Built For Performance

• Constructed from forged steel for high tensile strength under load
• Machined to OEM-equivalent dimensions for correct crank fitment
• Heat treated for wear resistance in high-rpm four-stroke service
• Supplied as a complete kit with rod, bearing, and pin
• Balanced to match original rotating assembly requirements

Fits These Machines

• for KTM XC-F 450 2008
• for KTM XC-F 450 2009

On-The-Job Use

• Bottom-end rebuilds on 2008-2009 XC-F 450 engines
• Crank assembly repair after rod bearing failure
• Top-end service jobs that extend into the crankcase
• Race prep and preventative maintenance on high-hour engines

Specs At A Glance

Good To Know

Q: Does this kit include the rod bearing? A: Yes, the kit ships with the connecting rod, bearing, and pin as a matched set. Reuse of old hardware is not advised during a rebuild.

Q: Can I install this without splitting the cases? A: Connecting rod replacement requires splitting the crankcase and pressing the crank. Professional engine assembly is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.