05047980AE Variable Valve Multiair Actuator Assy Fit 2014-23 Chrysler Dodge Jeep

Variable Valve Multiair Actuator Assembly for Chrysler, Dodge, Jeep

This variable valve Multiair actuator assembly (part number 05047980AE) replaces the original solenoid on 2014-2023 Chrysler, Dodge, and Jeep models with a Multiair engine, restoring accurate valve timing and combustion efficiency.

Overview

The variable valve Multiair actuator assembly is a critical engine management component that controls oil flow to adjust intake valve lift. This actuator fits a broad range of 2014-2023 Chrysler, Dodge, and Jeep vehicles equipped with Multiair technology, helping mechanics and owners fix rough idling, misfires, and power loss. Whether a shop is performing a top-end overhaul or a DIYer is troubleshooting a check engine light, this actuator delivers OEM-quality function.

Built For Performance

• Exact OEM-spec solenoid winding for consistent magnetic response
• Precision-machined spool valve tolerances ensure leak-free hydraulic control
• Corrosion-resistant body and connectors stand up to underhood heat cycles
• Plug-and-play electrical connector matches factory harness without adapters
• Tested across the full 2014-2023 model year range for stable actuation
• Supports variable valve timing strategies that boost low-end torque and fuel economy

On-The-Job Use

• Replacing a failed Multiair actuator to clear P000A or P000B trouble codes
• Restoring smooth acceleration after oil contamination degrades the factory unit
• Engine rebuilding projects that require fresh oil-control hardware
• Preventative maintenance on high-mileage fleet sedans and SUVs
• Diagnostic swaps to verify whether the actuator is causing performance issues

Specs At A Glance

Good To Know

Q: How do I confirm this actuator fits my engine? A: Check your vehicle’s build sheet for Multiair technology and verify that your original part number matches 05047980AE or crosses to this replacement.

Q: Will I need to perform an oil change after installation? A: It is recommended to change the engine oil and filter before installing the new actuator to prevent debris from clogging the oil passages.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.