0675-163 Impeller Shaft for Tiger Shark Daytona 770 1996-1997

Impeller Shaft for Tiger Shark Daytona 770

This impeller shaft, part number 0675-163, connects the engine drive to the impeller in the jet pump of 1996-1997 Tiger Shark Daytona 770 personal watercraft.

Overview

The impeller shaft for the Tiger Shark Daytona 770 is a driveline component that carries power from the engine to the jet pump impeller. This 0675-163 shaft is intended for the 1996-1997 model years and suits riders replacing a worn, bent, or corroded shaft. A straight, true-running impeller shaft keeps the Daytona 770 pump delivering consistent thrust.

Built For Performance

• Machined to the 0675-163 dimensional specification for correct spline and bearing fit
• Constructed from corrosion-resistant steel suited to marine environments
• Straightness held to tight tolerance to reduce pump vibration
• Spline profiles cut for positive engagement with the impeller
• Balanced design to support smooth high-RPM operation

Fits These Machines

• for Tiger Shark Daytona 770, 1996
• for Tiger Shark Daytona 770, 1997

On-The-Job Use

• Jet pump rebuilds and driveline refreshes on the Daytona 770
• Replacing a shaft damaged by debris ingestion or bearing failure
• Restoring thrust and reducing vibration in a worn jet drive
• Routine pump service when the drive line is opened up

Specs At A Glance

Good To Know

Q: Does this shaft fit both the 1996 and 1997 Daytona 770? A: This listing covers the 1996-1997 Daytona 770, so match your exact model year before ordering. Q: Should the pump bearings be replaced at the same time? A: Replacing bearings and seals while the pump is apart is common practice and helps the new shaft last.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.