0675-163 Impeller Shaft for Tiger Shark Monte Carlo 1000 1997

Impeller Shaft for Tiger Shark Monte Carlo 1000

This impeller shaft, part number 0675-163, connects the engine drive to the impeller in the jet pump of a 1997 Tiger Shark Monte Carlo 1000 personal watercraft.

Overview

The impeller shaft for the Tiger Shark Monte Carlo 1000 is a driveline component that transfers rotational power from the engine to the jet pump impeller. This 0675-163 shaft is made for the 1997 model year and serves riders replacing a worn, bent, or corroded shaft. A straight, true-running impeller shaft keeps the pump delivering consistent thrust for the Monte Carlo 1000.

Built For Performance

• Machined to the 0675-163 dimensional specification for correct spline and bearing fit
• Constructed from corrosion-resistant steel suited to marine environments
• Straightness held to tight tolerance to reduce pump vibration
• Spline profiles cut for positive engagement with the impeller
• Balanced design to support smooth high-RPM operation

Fits These Machines

• for Tiger Shark Monte Carlo 1000, 1997

On-The-Job Use

• Jet pump rebuilds and driveline refreshes on the Monte Carlo 1000
• Replacing a shaft damaged by debris ingestion or bearing failure
• Restoring thrust and reducing vibration in a worn jet drive
• Routine pump service when the drive line is opened up

Specs At A Glance

Good To Know

Q: Does this shaft fit other Tiger Shark models? A: This listing covers the 1997 Monte Carlo 1000 only, so verify your model and year before ordering. Q: Should the pump bearings be replaced at the same time? A: Replacing bearings and seals while the pump is apart is common practice and helps the new shaft last.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.