Skip to product information
1 of 1

0902-024 Knock Sensor for Arctic Cat M8000 All 2018-2022

0902-024 Knock Sensor for Arctic Cat M8000 All 2018-2022

Regular price $94.59
Regular price Sale price $94.59
Sale Sold out
Quantity

Knock Sensor for Arctic Cat M8000

This knock sensor for Arctic Cat monitors combustion noise on the M8000 engine, cross-referencing OEM part 0902-024 as a direct replacement.

Overview

This knock sensor for Arctic Cat is an engine management part that listens for detonation inside the cylinder and reports it to the ECU. Timing is then pulled back to protect the engine under load. It suits riders servicing an M8000 mountain sled across the 2018 to 2022 model years.

Built For Performance

  • Piezo-electric element tuned to factory knock frequency
  • Threaded body for secure mounting to the engine block
  • Sealed electrical connector resists snow, moisture, and vibration
  • Heat-resistant housing built for high-output two-stroke engines
  • Direct-fit replacement for OEM part 0902-024

Fits These Machines

  • for Arctic Cat M8000, 2018-2022

On-The-Job Use

  • Deep snow and mountain riding where throttle load swings hard
  • Engine diagnostics when knock fault codes appear
  • Top-end rebuilds and engine management service

Specs At A Glance

Part Number(s) 0902-024
Type Knock sensor
Fitment for Arctic Cat M8000, 2018-2022

Good To Know

Q: What are the signs of a failed knock sensor? A: A check engine light, power loss, or stored ECU codes for the knock circuit are the usual indicators. Damaged wiring or a cracked sensor body also call for replacement.

Q: Is calibration needed after fitting this sensor? A: These machines do not normally require calibration after sensor replacement. Torque it to spec and clear any stored fault codes before the next ride.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details