1*PAIR Front Lower Control Arms for 2006-2010 INFINITI M35 M45 54500EG01A RWD

Front Lower Control Arms for INFINITI M35 and M45

This pair of front lower control arms replaces worn units on rear wheel drive 2006 to 2010 INFINITI M35 and M45 models, with part number 54500EG01A as a reference for the correct fit.

Overview

These front lower control arms are a direct replacement option for worn suspension arms on the INFINITI M35 and M45. Each arm locates the lower suspension and carries the ball joint and bushings that keep steering and alignment stable. The pair suits owners servicing front end play or worn bushings on rear wheel drive 2006 to 2010 models.

Built For Performance

• Pair of front lower control arms for left and right sides
• Forged or stamped steel arm construction built for suspension loads
• Integrated ball joint position for direct mounting at the knuckle
• Bushings installed at the chassis mounting points
• OEM reference 54500EG01A for cross checking fitment

Fits These Machines

• for INFINITI M35 2006 to 2010 rear wheel drive
• for INFINITI M45 2006 to 2010 rear wheel drive

On-The-Job Use

• Replacing worn lower control arms during front suspension service
• Correcting steering play and vague handling from worn bushings
• Restoring alignment geometry before a wheel alignment
• Front end rebuilds on higher mileage M35 and M45 models

Specs At A Glance

Good To Know

Q: Do these control arms fit all wheel drive M35 and M45 models? A: No, this pair is intended for rear wheel drive models only. Check your drivetrain configuration before ordering.

Q: Is an alignment needed after installing these control arms? A: Yes, a wheel alignment should be performed after replacing front lower control arms. The new arms change suspension geometry and need to be set to spec.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.