11004-3710 Head Gasket for Kawasaki X2 650 1986-1995

Head Gasket for Kawasaki

This head gasket for Kawasaki replaces OEM part 11004-3710, sealing the cylinder head to the engine block on X2 650 watercraft for proper compression and cooling.

Overview

This head gasket for Kawasaki is a direct-fit sealing component for the X2 650 personal watercraft produced from 1986 to 1995. The gasket sits between the cylinder head and cylinder block, maintaining compression and keeping coolant passages sealed under heat and pressure. It suits riders and mechanics performing top-end rebuilds on 650cc Kawasaki engines.

Built For Performance

• Cross-references OEM part 11004-3710 for direct fitment
• Seals combustion chamber and coolant passages under high compression
• Constructed to withstand the heat cycles of a marine two-stroke engine
• Designed for the 650cc engine family used in the X2 platform
• Provides a reliable seal for top-end service and rebuilds
• Sold as a single gasket for one cylinder head installation

Fits These Machines

• for Kawasaki X2 650 (1986-1995)

On-The-Job Use

• Top-end rebuilds after a blown head gasket or overheating event
• Cylinder head removal and reinstallation on 650cc engines
• Routine engine freshening on older X2 watercraft
• Compression restoration during a rebuild

Specs At A Glance

Good To Know

Q: Does this gasket fit other Kawasaki 650 models? A: This gasket is listed for the X2 650 from 1986 to 1995, but fitment can vary by model and year, so verify your engine before ordering.

Q: Should I replace head bolts too? A: Many rebuilders reuse head bolts if they are within spec, but inspect them for stretch or corrosion during the job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.