11004-3722 Head Gasket for Kawasaki Ultra 250X 1500 2007-2008

Head Gasket for Kawasaki Ultra 250X 1500

This head gasket for Kawasaki seals the cylinder head to the engine block on the Ultra 250X 1500, cross-referenced to OEM part number 11004-3722.

Overview

This head gasket for Kawasaki is a direct-fit sealing component for the Ultra 250X 1500 jet ski engine. It maintains compression at the head-to-block joint so the engine runs cleanly under load. Built for riders and mechanics replacing a blown or worn gasket on the 2007-2008 Ultra 250X.

Built For Performance

• Precision-cut to match the Ultra 250X 1500 cylinder head and block mating surfaces
• Cross-referenced to OEM part number 11004-3722 for confident fitment
• Constructed to hold compression under sustained high-RPM marine use
• Resists coolant and combustion heat cycling typical of personal watercraft engines
• Direct replacement for the factory head gasket on the listed model years

Fits These Machines

• for Kawasaki Ultra 250X 1500 (2007-2008)
• for Kawasaki Ultra 250X

On-The-Job Use

• Top-end rebuilds after head gasket failure
• Cylinder head removal and reinstall jobs
• Compression recovery on high-hour engines
• Preventive replacement during engine service

Specs At A Glance

Good To Know

Q: Does this gasket require a specific torque sequence? A: Yes, always follow the factory torque sequence and spec for the Ultra 250X 1500 head bolts when installing this gasket. Skipping the sequence can cause leaks or premature failure.

Q: Can I reuse this head gasket after removal? A: No, head gaskets are single-use and should be replaced any time the cylinder head is removed. Reinstall with a fresh gasket for a reliable seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.